Block-level wiring for both vehicles, with the Teensy 4.1 pin assignment used by the firmware. The tables below are the same pin map as firmware/*/include/pins.h.
battery / power (high current)5 V / 6 V railssignal (digital)bus (SPI / I²C / UART)
Pin map
Wiring rules
One ground star point at the flight computer. Never daisy-chain servo ground through the logic board.
Servo power rail is separate from the logic rail; join grounds only. In the rocket the servos have their own battery (pack B).
Solder or use locking connectors. No bare Dupont jumpers in flight hardware: vibration will unseat them.
Twist motor phases and battery leads; keep them away from the IMU and receiver antenna.
The remove-before-flight pin/loop breaks the main battery supply: the motors and servos cannot move with it in.