Two brushless motors, steered by servos through a geared two-axis gimbal. Build it from the printed parts to the first tethered hover, after proving the electronics on a vane-controlled monocopter.
Phase 1 is a monocopter with four vanes in the prop wash. It proves the flight computer, the attitude filter, the control loop, the servos, the logging and the way you work.
Phase 2 reuses all of it on RK-1: a coaxial pair of brushless motors in a gimbal, a three-plate stack and four legs.
Three stack plates, geared gimbal, coaxial brushless pair, four legs.
[ Open model → ] Phase 1One prop, four vanes in the wash. The test vehicle for the electronics.
[ Open model → ] BuildEvery step highlighted on the model, with checks before you move on.
[ Start building → ]Gains, latency, actuator lag and noise on a single-axis attitude loop. Presets for the rocket and the monocopter.
[ Open lab → ]Thrust, lever arm, gear ratio, servo torque and resolution in one interactive page.
[ Open lab → ]Live mass budget from the bill of materials, thrust to weight, hover power and endurance.
[ Open calculator → ]Block diagrams and the Teensy 4.1 pin map for both vehicles.
[ Open diagrams → ]Eighteen print-ready STL files for the rocket: stack plates, landing frame, gimbal, gears, cage, legs. Preview and download each one.
[ Open parts → ]Searchable parts list with mass and cost for both vehicles, with CSV download.
[ Open table → ]Ten steps from printing to tethered hover.
[ Start building → ]