TVC Rocket / Open build guide Start building/

TVC
Rocket

RK-1 · Phase 2 · electric thrust-vector control

Two brushless motors, steered by servos through a geared two-axis gimbal. Build it from the printed parts to the first tethered hover, after proving the electronics on a vane-controlled monocopter.

Open build guide
Two phases

An electric rocket that stands on its own thrust.

Phase 1 is a monocopter with four vanes in the prop wash. It proves the flight computer, the attitude filter, the control loop, the servos, the logging and the way you work.

Phase 2 reuses all of it on RK-1: a coaxial pair of brushless motors in a gimbal, a three-plate stack and four legs.

Take-off mass1.06 kg
Thrust to weight2.5
Gimbal range±7°
Control loop500 Hz

Build

Models

Every part is drawn from one parameter file. Open a model to explode it, inspect parts and drive the actuators.

Labs

Tools

Gains, latency, actuator lag and noise on a single-axis attitude loop. Presets for the rocket and the monocopter.

[ Open lab → ]

Thrust, lever arm, gear ratio, servo torque and resolution in one interactive page.

[ Open lab → ]

Live mass budget from the bill of materials, thrust to weight, hover power and endurance.

[ Open calculator → ]

Block diagrams and the Teensy 4.1 pin map for both vehicles.

[ Open diagrams → ]

Eighteen print-ready STL files for the rocket: stack plates, landing frame, gimbal, gears, cage, legs. Preview and download each one.

[ Open parts → ]

Searchable parts list with mass and cost for both vehicles, with CSV download.

[ Open table → ]

Ten steps from printing to tethered hover.

[ Start building → ]

Requirements, procedures and gates, in full.